85' Vmax Pump Drive Gear O-Ring Specs??

[KylejSmith]

Looking for the Specs of the Pump Drive Gear O-Ring. I've been to a few O-Ring shops and they can't seem to match it, anyone have a # I could give them to speed this up?

Thanks,

[Vmax540]

Which o-ring ?

[KylejSmith]

The large one that goes around the whole housing.

[KylejSmith]

Its the one, that the "NOTE" points to, telling you to grease the O-Ring.

[vmax-540]

Yamaha Part # is 93211-44445-00 I have reused them as long as they are in good condition you should be OK. If you can find the right diameter seal in a roll you could always fit it in the groove with the ends at the top and put a drop of silicone on the ends. It is always best to find the original one if you can, these are just a few alternatives for you if you can't..